Audio Unit Removal/Installation; Audio Unit Connector Replacement - Honda 2002 Accord Manual

Stereo Sound System
Audio Unit Removal/installation
SRS components are located in this area. Review the
SRS component locations, precautions and procedures
in the SRS section before performing repairs or service
(see page 23-28).
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the dashboard and related
parts.
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the radio's
preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the center panel (see page 20-86).
4. Remove the bolts, disconnect the audio unit
connectors (A) and the antenna lead (B), then
remove the audio unit.
F a s t e n e r L o c a t i o n s
• . Bolt, 4
5
x
0.8 mm
9 N - m
( 0 . 9 k g f m ,
7 I b f f t )
5. Install in the reverse order of removal, and note
these items:
• Make sure the audio unit connectors are plugged
in properly, and the antenna lead is connected
properly.
• Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
Audio Unit Connector Replacement
When replacing an audio unit connector, match the
wires to the cavities as listed in the following table.
Cavities 1, 3, 11, 12, and 13 are not used.
Cavity
Wire Connects to
2 WHT/RED ACC (Main stereo power
supply)
4 BLU Security in
5 RED/YEL Right rear speaker (+ )
6 BLU/YEL Left rear speaker (+)
7 RED/GRN Front passenger's speaker
( + )
Right tweeter ( + )
8 BLU/GRN Driver's door speaker ( + )
Left tweeter ( + )
9 RED/BLK Lights-on signal
10 WHT/GRN Constant power
1 4 * BLK Security out
15 BRN/WHT Right rear speaker (—)
16 GRY/WHT Left rear speaker (—)
17 BRN/BLK Front passenger's door
speaker( —)
Right tweeter (-)
18 GRY/BLK
Driver's door speaker ( — )
Left tweeter ( —)
19 RED Multiplex control unit,
driver's
20 BLK Ground (G502)
* : '98-00 models
OJ OJ
('
"\
OJ
U L
OJ
© o
®
(©I
® o
c p
1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20
22-124