Table of Contents
Advertisement
ENGINE MECHANICAL - Cylinder Block
EM-107
81555
EM4603
EM1649
INSTALLATION OF ENGINE (4A-GZE)
1.
INSTALL TRANSAXLE TO ENGINE
M/T vehicle (See page MT -96)
A/T vehicle (See page AT -144)
2.
INSTALL STARTER (See page ST-12)
3.
(A/T vehicle)
INSTALL SIX TORQUE CONVERTER MOUNTING BOLT
(a)
First, install the gray bolt and then five black bolts.
(b)
Tighten the bolts evenly.
Torque:
280 kg-em (20 ft-lb, 27 N·m)
4.
INSTALL FLYWHEEL HOUSING UNDER COVER
{a)
Install the under cover with the three bolts (M/T) or
two bolts {A/T).
{b)
{A/T vehicle)
Install the stiffener plate with the three bolts. Tighten
the bolts.
Torque:
380 kg-em (27 ft-lb, 37 N·m)
5.
INSTALL WATER INLET WITH HOUSING
{a)
Connect the two hoses to the No.
1
and No. 2 water
by-pass pipes.
{b)
Install the water inlet and housing with the nut.
{c)
Connect the vacuum hoses to BVSV.
6.
INSTALL ENGINE WITH TRANSAXLE
{a)
Set the engine with transaxle in the engine saddle as
shown.
Advertisement
Table of Contents
Troubleshooting
