Toyota MR2 1988 Repair Manual page 61

EM-18
ENGINE MECHANICAL- Timing Belt
EM1585
14. REMOVE CRANKSHAFT TIMING PULLEY
NOTE: If the pulley is difficult to remove by hand,
remove using SST.
SST 09950-20017
15. (4A-GZE)
REMOVE OIL COOLER HOSE
16. (A/T vehicle)
DISCONNECT A/T THROTTLE CABLE
17. DISCONNECT ACCELERATOR CABLE
18. (w/ Cruise control)
DISCONNECT CRUISE CONTROL CABLE
19. REMOVE PCV HOSE
20. (4A-GE)
REMOVE ACCELERATOR LINK AND SPEEDOMETER
CABLE CLAMP
Remove the four bolts, accelerator link and speedometer
cable clamp.
21. (4A-GZE
w/
Cruise control)
REMOVE ACCELERATOR LINK
Disconnect accelerator rod, and remove the three bolts
and accelerator link.
22. REMOVE CYLINDER HEAD COVERS
{a) Disconnect following wires:
• Engine compartment cooling fan motor connector
• Noise filter connector
• Distributor wire connectors
• Oil pressure sender gauge connector
• {w/ A/C)
Compressor connector
{b) Remove the four bolts, center cover and gasket.
{c) Remove the eight cap nuts, seal washers, two head
"----------------=eM:::.1:..::;:ss::.;...~7
covers and gaskets.