Inspect Synchronizer Rings - Toyota MR2 1988 Repair Manual

MANUAL TRANSAXLE- C52 Transaxle MT-19
WM0066
Z9220 82687
~~~:ST
r ;I~--------,
i'
1 - -
-
I
Z9221 82688
4. INSPECT SYNCHRONIZER RINGS
(a) Check for wear or damage.
(b) Turn the ring and push it in to check the braking
action.
(c) Measure the clearance between the synchronizer ring
back and the gear spline end.
Minimum clearance: 0.6 mm (0.024 in.)
If the clearance is less than the limit. replace the syn-
chronizer ring.
5. MEASURE CLEARANCE OF SHIFT FORKS AND HUB
SLEEVES
Using a feeler gauge, measure the clearance between the
hub sleeve and shift fork.
Maximum clearance: 1.0 mm (0.039 in.)
If the clearance exceeds the limit, replace the shift fork or
hub sleeve.
6. IF NECESSARY, REPLACE INPUT SHAFT FRONT
BEARING
(a) Using SST. pull out the bearing.
SST 09308-00010
(b) Using SST, press in a new bearing.
SST 09310-3501 0