Toyota MR2 1988 Repair Manual page 97

ENGINE MECHANICAL - Cylinder Head (4A-GE)
34. CONNECT HEATER HOSE TO CYLINDER HEAD REAR
COVER
35. CONNECT FOLLOWING VACUUM HOSES:
• Brake booster hose.
• (w/ Cruise control)
Cruise control vacuum hose to intake manifold.
36. INSTALL ACCELERATOR LINK AND SPEEDOMETER
CABLE CLAMP
(a) Install the accelerator link and speedometer cable
clamp with the four bolts.
(b) Connect the accelerator cable and connecting rod.
(c) {w/ Cruise control)
Connect the cruise control cable.
37. INSTALL NO. 1 AIR CLEANER HOSE
(a) Install the air cleaner hoses with clamp. And tighten
the clamp bolts.
{b) Connect the VSV and air flow meter connector.
{c) Connect the vacuum hose to the air cleaner hose.
38. INSTALL AIR RESONATOR
39. REFILL WITH COOLANT (See page C0-4)
eM31ss
Capacity:
~---------------------------------~==
M/T
A/T
w/
Heater
12.2 liters (12.9 US qts, 10.7 Imp. qts)
Others
12.4 liters (13.1 US qts, 10.9 Imp. qts)
12.9 liters (13.6 US qts, 11.4 Imp. qts)
40. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
41. START ENGINE AND CHECK FOR LEAKS
42. PERFORM ENGINE ADJUSTMENT
Adjust the ignition timing.
(See steps 5 to 8 on pages IG-11, 12)
43. INSTALL ENGINE UNDER COVER
44. RERFORM ROAD TEST
Check for abnormal noise, shock, slippage, correct shift
points and smooth operation.
45. RECHECK ENGINE COOLANT AND ENGINE OIL
LEVELS