Table of Contents
Advertisement
AUTOMATIC TRANSAXLE- On-Vehicle Repair
AT-39
E1514
OR0026
OR0027
AT1945
E1534
INSTALLATION OF THROTTLE CABLE
1.
INSTALL CABLE IN TRANSMISSION CASE
(a)
Be sure to push it in all the way.
(b)
Install the retaining plate and one bolt.
2.
INSTALL VALVE BODY (See page AT-41)
3.
IF THROTTLE CABLE IS NEW, STAKE STOPPER TO
INNER CABLE
(a)
Bend the cable so there is radius of about 200 mm
(7.87 in.).
(b)
Pull the inner cable lightly until a slight resistance is
felt, and hold it.
(c)
Stake the stopper 0.8 - 1.5 mm (0.031 - 0.059 in.)
from the outer cable as shown.
4.
CONNECT THROTTLE CABLE
(a)
Connect the cable to the throttle linkage.
(b)
Connect the cable housing to the bracket.
(c)
Connect the cable to the clamps.
5.
ADJUST THROTTLE CABLE (See page AT-6)
6.
INSTALL NEUTRAL START SWITCH
(a)
Install the neutral start switch.
(b)
Install the manual shift lever.
(c)
Adjust the neutral start switch.
(See page AT -6)
(d)
Connect the transmission control cable.
7.
TEST DRIVE VEHICLE
Advertisement
Table of Contents
Troubleshooting
