Table of Contents
Advertisement
Fl-100
4A-GE
No Clearance
Throttle Stop Screw
4A-GZE
EFI SYSTEM - Air Induction System
F12992
FI0957
FI0509
Fl301 5
F10958
8.
REMOVE THROTTLE BODY
Remove the two bolts, two nuts and the throttle body with
the gasket.
INSPECTION OF THROTTLE BODY
1.
CLEAN THROTTLE BODY BEFORE INSPECTION
(a)
Wash and clean the cast parts with a soft brush and
carburetor cleaner.
(b)
Using compressed air, blow all passages and aper-
tures in the throttle body.
CAUTION:
To prevent deterioration, do not clean the
throttle position sensor and dash pot.
2.
CHECK THROTTLE VALVE
Check that there is no clearance between the throttle stop
screw and throttle lever when the throttle valve is fully
closed.
3.
CHECK THROTTLE POSITION SENSOR
(See step 2 on page Fl-98)
4.
IF NECESSARY, ADJUST THROTTLE POSITION
SENSOR
(a)
Loosen the two screws of the sensor.
Advertisement
Table of Contents
Troubleshooting
