Table of Contents
Advertisement
ENGINE MECHANICAL -
Cylinder Block
EM-71
EM4712 EM4725
EM1650
(b)
Remove the two bolts and nuts holding the RH
mounting bracket and RH mounting insulator.
(c)
Remove the two {M/T) or three {A/T) bolts holding
the LH mounting insulator and transaxle bracket.
{d)
Slowly raise the vehicle.
CAUTION:
Be careful not to damage the throttle
position sensor.
{e)
Make sure the engine is clear of all wiring, hoses and
cables.
36. REMOVE WATER INLET WITH HOUSING
{a)
Disconnect the start injector time switch connector.
(b)
Disconnect the vacuum hoses from BVSVs.
(c)
Remove the water inlet housing mounting nut.
(d)
Disconnect the two hoses from the No. 1 and No. 2
water by-pass pipes, and remove the water inlet
housing.
37. DISCONNECT FOLLOWING CONNECTORS:
• Back-up and neutral start switch connector
• Neutral start switch connector
• Transmission solenoid connector
38. REMOVE FL VWHEEL HOUSING UNDER COVER
(a)
(A/T vehicle)
Remove the three bolts and stiffener plate.
{b)
Remove the three bolts {M/Tl or two bolts (A/T} and
under cover.
Advertisement
Table of Contents
Troubleshooting
