Toyota MR2 1988 Repair Manual page 59

EM-16
ENGINE MECHANICAL - Timing Belt
EM4568
EM4569
6. REMOVE SPARK PLUGS
Using plug wrench (16 mm), mmove the spark plugs.
7. SET NO. 1 CYLINDER TO TDC/COMPRESSION
8.
{a) Turn the crankshaft pulley and align its groove with
the idler pulley bolt.
(b) Remove the oil filler cap and check that you can see
the cavity in the camshaft.
If necessary, turn the crankshaft pulley one complete
revolution.
REMOVE RH ENGINE MOUNTING INSULATOR
(a) Disconnect the high-tension cords from the ignition
coil.
(b) Disconnect the brake booster vacuum hose from the
intake manifold.
(c) (4A-GE w/ Cruise control)
Disconnect the cruise control vacuum hose from the
intake manifold.
(d) Slightly raise the engine with a jack.
NOTE: Place a wooden block between the jack and
engine.
(e) Remove the mounting through bolt.
{f) Remove the two nuts, bolt and RH engine mounting
insulator.
9. REMOVE CRANKSHAFT PULLEY
(a) Using SST to hold the crankshaft pulley, loosen the
pulley bolt.
SST 0921 3-7001 0 and 09330-00021
(b) Remove SST and pulley bolt.