Table of Contents
Advertisement
BR-20
BRAKE SYSTEM - Front Brake
80902 C9931
C9937
8.
INSTALL NEW PADS
(a)
Install a pad wear indicator plate to the pad.
NOTE:
Be sure the arrow on the pad wear indicator plate
is pointing in the rotating direction of the disc.
(b)
Install anti-squeal shims to the pad.
NOTE:
Apply disc brake grease to the both side of the
anti-squeal shim No. 3.
(c)
Install the pads onto each support plate.
CAUTION:
Do not allow oil or grease to get on the
rubbing face.
(d)
Install the two anti-squeal springs.
9.
INSTALL CYLINDER
(a)
Draw out a small amount of brake fluid from the
reservoir.
(b)
Press in piston with a hammer handle or an equiva-
lent.
NOTE:
Always change the pad on one wheel at a time as
there is a possibility of the opposite piston flying out.
(c)
Insert the brake cylinder carefully so the boot is not
wedged.
(d)
Install and torque two installation bolts.
Torque:
255 kg-em (18 ft-lb, 25 N·m)
10. INSTALL FRONT WHEEL
11. CHECK THAT FLUID LEVEL IS MAX LINE
Advertisement
Table of Contents
Troubleshooting
