Toyota MR2 1988 Repair Manual page 76

3 5
2
6 9
ENGINE MECHANICAL - Cylinder Head (4A-GE) EM-33
4
7
3
2
EM0510
EM1623
EM2594
42. REMOVE CAMSHAFTS
(a) Uniformly loosen and remove the bearing cap bolts in
several passes, in the sequence shown.
(b) Remove the bearing caps, oil seal and camshaft.
NOTE: Arrange the intake and exhaust camshafts.
43. REMOVE CYLINDER HEAD
(a) Using SST, uniformly loosen and remove the ten
cylinder head bolts in several passes, in the sequence
shown.
SST 09205-16010
CAUTION: Head warpage or cracking could result
from removing bolts in incorrect order.
(b) Lift the cylinder head from the dowels on the cylinder
block and place the head on wooden blocks on a
bench.
NOTE: If the cylinder head is difficult to lift off, pry with
a screwdriver between the cylinder head and block
saliences.
CAUTION: Be careful not to damage the cylinder
head and cylinder block surfaces of cylinder head
gasket side.