Remove Oil Tubes; Remove Valve Body; Installation Of Valve Body; Place Valve Body On Transmission - Toyota MR2 1988 Repair Manual

AUTOMATIC TRANSAXLE- On-Vehicle Repair
AT-41
06205
AT2222
82138
7. REMOVE OIL TUBES
Pry up both tube ends with a large screwdriver and
remove the five tubes.
8.
DISCONNECT SOLENOID CONNECTORS
9. REMOVE MANUAL DETENT SPRING
10. REMOVE VALVE BODY
(a) Remove the twelve bolts.
(b) Disconnect the throttle cable from the cam.
(c) Disconnect the manual valve connecting rod and
remove the valve body.
11. REMOVE SECOND BRAKE APPLY GASKET
DISASSEMBLY OF VALVE BODY
(See page AT -96)
INSTALLATION OF VALVE BODY
1. INSTALL SECOND BRAKE APPLY GASKET
2. PLACE VALVE BODY ON TRANSMISSION
(a) Connect the manual valve connecting rod.
(b) While holding the cam down with your hand, slip the
cable end into the slot.
(c) Bring valve body into place.
CAUTION: Be careful not to entangle the solenoid
wire.