Table of Contents
Advertisement
STEERING - Steering Column Assembly
SR-7
C9864
C9868
DISASSEMBLY OF STEERING COLUMN
ASSEMBLY
1.
REMOVE COMBINATION SWITCH
(a)
Remove the clamp.
(b)
Remove the two screws from the connector.
(c)
Remove the four screws and combination switch.
2.
REMOVE TENSION SPRINGS AND GROMMETS
(a)
Pull down the tension springs, and remove the grom-
mets.
(b)
Remove the bolts and springs.
3.
REMOVE BREAKAWAY BRACKET
(a)
Remove the set bolt and tilt lever.
NOTE:
The bolt has LH threads.
(b)
Remove the adjusting nut and washer, and pull out
the lock bolt.
(c)
Remove the two screws and breakaway bracket.
4.
REMOVE TILT STEERING SUPPORT
(a)
Remove the two nuts and the pawl set bolts.
(b)
Remove the bushings, 0-rings and tilt steering sup-
port.
5.
REMOVE UPPER BRACKET FROM MAIN SHAFT
(a)
Remove the three screws and retainer from the upper
bracket.
(b)
Using snap ring pliers, remove the snap ring.
(c)
Release the steering lock.
Advertisement
Table of Contents
Troubleshooting
