Remove Snap Ring - Toyota MR2 1988 Repair Manual

1st Gear
MANUAL TRANSAXLE - C52 Transaxle
MT0059
MT0060
MT0061
2nd
Gear
82670 82671
29. REMOVE RADIAL BALL BEARING, FOURTH GEAR,
NEEDLE ROLLER BEARINGS AND SYNCHRONIZER
RING FROM INPUT SHAFT
(a) Using SST and a press, remove the radial ball bear-
ing.
SST 09950-00020
(b) Remove the 4th gear, needle roller bearings and syn-
chronizer ring.
30. REMOVE SNAP RING
Using two screwdrivers and a hammer, tap out the snap
ring.
31. REMOVE NO. 2 HUB SLEEVE ASSEMBLY, THIRD
GEAR, SYNCHRONIZER RING AND NEEDLE
ROLLER BEARINGS
Using SST and a press, remove No. 2 hub sleeve, 3rd gear,
synchronizer ring and needle roller bearings.
SST 09950-00020
32. MEASURE FIRST AND SECOND GEAR THRUST
CLEARANCE
Using a feeler gauge, measure the thrust clearance.
Standard clearance:
1st gear 0.10- 0.40 mm
(0.0039 - 0.01 57 in.l
2nd gear 0.1 0 - 0.45 mm
(0.0039- 0.0177 in.)
Maximum clearance:
1st gear 0.45 mm (0.0177 in.)
2nd gear 0.50 mm (0.0197 inJ
33. REMOVE RADIAL BALL BEARING, FOURTH DRIVEN
GEAR AND SPACER FROM OUTPUT SHAFT
(a) Using SST and a press, remove the radial ball bearing
and 4th driven gear.
SST 09950-00020
(b) Remove the spacer.