Toyota MR2 1988 Repair Manual page 64

Timing Mark
ENGINE MECHANICAL - Timing Belt
EM-21
EM1589
INSTALLATION OF TIMING BELT
(See page EM-15)
1. INSTALL CAMSHAFT TIMING PULLEYS
(a) Position the knock pin of the camshafts as shown in
the figure.
(b) Align the camshaft knock pin with the knock pin
groove of the pulley, and slide the pulley, facing the
timing mark upward.
(c) Secure the hexagonal portion of the camshaft, and
install the plate washer and bolt. Torque the bolt.
Torque: 475 kg-em (34 ft-lb, 47 N·m)
CAUTION: Be careful not to damage the cylinder
head with the wrench.
2. INSTALL CYLINDER HEAD COVERS WITH GASKET
(a) Apply seal packing to the cylinder head as shown in
the figure.
Seal packing: Part No. 08826-00080 or equivalent
(b) Install the gaskets to the head covers.
(c) Install the two head covers with the four seal
washers and cap nuts.
Torque: 130 kg-em (9 ft-lb, 13 N·m)
(d) Install the gasket to the center cover.
(e) Install the center cover with the four bolts.
Connect the following wires:
• Distributor wire connector
• Engine compartment cooling fan motor connector
• Oil pressure sender gauge connector
• (w/
A/C)
Compressor connector
• Noise filter connector
3. (4A-GE}
INSTALL ACCELERATOR LINK AND SPEEDOMETER
CABLE CLAMP
Install the accelerator link and speedometer cable clamp
with the four bolts.