Installation Of Throttle Body - Toyota MR2 1988 Repair Manual

Fl-104 EFI SYSTEM - Air Induction System
F7222
\
I
I
Fl2992
(c) Turn the sensor clockwise, and temporarily install the
two screws.
3. ADJUST THROTTLE POSITION SENSOR
(See step 4 on page Fl-1 00)
INSTALLATION OF THROTTLE BODY
(4A-GE)
1. INSTALLTHROTTLEBODY
Place on a new gasket and install the throttle body with
two bolts and two nuts.
Torque: 220 kg-em (16 ft-lb, 22 N·m)
2. CONNECT ACCELERATOR CABLE
3. INSTALL ACCELERATOR RETURN SPRING
4. CONNECT WATER AND VACUUM HOSES
5. CONNECT THROTTLE POSITION SENSOR
CONNECTOR
6. INSTALL AIR CLEANER HOSE NO. 1
7. REFILL WITH COOLANT
(4A-GZE)
1. INSTAll THROTTLE BODY
Place on a new gasket and install the throttle body with
two bolts and two nuts.
Torque: 220 kg-em (16 ft-lb, 22 N·m)
2. CONNECT TWO WATER BY-PASS HOSES
3. INSTALL INTAKE AIR CONNECTOR
Place on a new gasket and install the throttle body with
two bolts and two nuts.
Torque: 100 kg-em (7 ft-lb, 1 0 N ·m)
4. CONNECT THROTTLE CABLE (A/T)
5. CONNECT ACCELERATOR CABLE