Toyota MR2 1988 Repair Manual page 762

BRAKE SYSTEM - Rear Brake BR-31
~
Socket Wrench
(14 mm)
-+--+--SST
C9965
C9966
C9967
C9968
C9969
6. REMOVE SNAP RING FROM CYLINDER
(a) Set SST onto the adjusting bolt, and lightly tighten it
with a 14 mm socket.
SST
09756-00010
CAUTION:
• To insure safety, always use SST as there is a
possibility of the spring flying out, causing injury or
damaging to the interior surface of the cylinder.
• Be careful not to tighten the SST too tightly as this
may damage the spring retainer.
(b) Using snap ring pliers, remove the snap ring from the
cylinder.
7. REMOVE ADJUSTING BOLT
From the cylinder, pull out the spring retainer, spring,
spring plate and stopper together with the adjusting bolt.
CAUTION:
• Be careful not to pry too hard.
• Be careful not to damage the 0-ring.
8. DISASSEMBLE ADJUSTING BOLT
(a) Remove SST.
SST
09756-00010
(b) Remove the spring retainer, spring, spring plate and
stopper from the adjusting bolt.
(c) Remove the 0-ring from the adjusting bolt.
9. REMOVE STRUT
10.
REMOVE TORSION SPRING FROM PARKING
BRAKE CRANK