Table of Contents
Advertisement
AT-144
AUTOMATIC TRANSAXLE - Installation of Transaxle
A1962
AT1843
00291
62150
INSTALLATION OF TRANSAXLE
1.
INSTALL TORQUE CONVERTER IN TRANSMISSION
2.
CHECK TORQUE CONVERTER INSTALLATION
Using calipers and a straight edge, measure from the
installed surface to the front surface of the transmission
housing.
Correct distance:
23 mm (0.906 in.) or more
3.
ALIGN TRANSMISSION AT INSTALLATION POSITION
(a)
Align the two knock pins on the block with the con-
verter housing.
(b)
Temporarily install one bolt.
4.
INSTALL TRANSMISSION HOUSING MOUNTING
BOLTS
TORQUE:
650 kg-em (47 ft-lb, 64 N·m)
5.
INSTALL TRANSMISSION MOUNTING SET BOLTS
Torque:
1,150 kg-em (83 ft-lb, 113 N·m)
6.
INSTALL FRONT AND REAR MOUNTING BOLTS
Torque:
530 kg-em (38 ft-lb, 52 N·m)
7.
INSTALL DRIVE SHAFTS
(See Page RA-27)
8.
INSTALL TORQUE CONVERTER MOUNTING BOLTS
(a)
First, install the gray bolt and then five black bolts.
(b)
Tighten the bolts evenly.
Torque:
280 kg-em (20 ft-lb, 27 N·m)
9.
INSTALL ENGINE REAR END PLATE
Advertisement
Table of Contents
Troubleshooting
