Toyota MR2 1988 Repair Manual page 767

BR-36 BRAKE SYSTEM - Rear Brake
C9984
C9967
C9986
C9987
10.
ASSEMBLE ADJUSTING BOLT
(a) Assemble the stopper, plate, spring and spring
retainer to the adjusting bolt. and using SST, fully
tighten them down by hand.
SST 09756-00010
CAUTION:
• Position the inscribed surface of the stopper
upward.
• Align the notches of the spring case with the
notches of the stopper.
(b) Install the adjusting bolt subassembly into the
cylinder.
11. INSTALL SNAP RING
(a) Using snap ring pliers, install1 the snap ring.
NOTE: Face the snap ring opening toward the bleeder
side.
(b) Remove the SST.
SST
09756-00010
(c) Firmly pull up the adjusting bolt by hand and insure
that it does not move.
12. PERFORM OPERATIONAL CHECK
After performing steps
1
to
11,
move the parking brake
crank by hand and insure that the adjusting bolt moves
smoothly.
13.
INSTALL PISTON SEAL IN CYLINDER