Table of Contents
Advertisement
AT-112
AUTOMATIC TRANSAXLE- Assembly of Transmission
ASSEMBL V OF TRANSMISSION
(See pages AT-50 to 52)
Disassembly, inspection and assembly of each
component group have been indicated in the
preceding chapter.
GENERAL ASSEMBLY NOTES:
1.
The automatic transmission is composed of
highly precision-finished parts, necessitating
cmeful inspection before assembly because
even a small nick could cause fluid leakage or
affect performance.
2.
Before assembling new clutch discs, soak
them in automatic transmission fluid 'for at
least two hours.
3.
Apply automatic transmission fluid on the
sliding or rotating surfaces of parts before
assembly.
4.
Use petroleum jelly to keep small parts in
their places.
Before assembly, make sure again that all com-
ponent groups are assembled correctly. If
something wrong is found in a certain compo-
nent group during assembly, inspect and repair
this group immediately. Recommended ATF:
DEXRON®ll.
5.
Do not use adhesive cements on gaskets and
similar parts.
6.
When assembling the transmission, be sure
to use new gaskets and 0-rings.
7.
Dry all parts by blowing with compressed air.
Never use shop rags.
8.
Be sure to install the thrust bearings and
races in the correct direction and position.
AT1312
Advertisement
Table of Contents
Troubleshooting
