Table of Contents
Advertisement
CLUTCH - Clutch Unit
CL-15
C6094
82000 82001
112002 112003
(4A-GZE)
Using a dial indicator and measuring point, check the
diaphragm spring tip alignment.
Maximum non-alignment:
0.5 mm (0.020 in.)
3.
IF NECESSARY, ADJUST SPRINGS
Using SST, adjust the diaphragm spring tip alignment.
SST 09333-00013
4.
APPLY MOLYBDENUM DISULPHIDE LITHIUM BASE
GREASE (NLGI NO. 2) TO FOLLOWING PARTS:
(a)
Release fork and hub contact point
(b)
Release fork and push contact point
(c)
Release fork pivot point
(d)
Clutch disc spline
(e)
Release bearing hub inside groove
5.
INSTALL RELEASE BEARING, FORK AND BOOT
FROM TRANSAXLE
(a)
Install the bearing assembly to the fork, and then
install them to the transaxle.
(b)
Install the boot.
6.
INSTALL TRANSAXLE TO ENGINE
(See page MT-37)
Advertisement
Table of Contents
Troubleshooting
