Table of Contents
Advertisement
CLUTCH - Clutch Master Cylinder
CL-7
CL0330
CL0329
INSPECTION OF MASTER CYLINDER
NOTE:
Clean the disassembled parts with compressed
air.
1.
INSPECT MASTER CYLINDER BORE FOR SCORING OR
CORROSION
If a problem is found, clean or replace the cylinder.
2.
INSPECT PISTON AND CUPS FOR WEAR, SCORING,
CRACKS OR SWELLING
If either one requires replacement, use the parts from the
cylinder kit.
3.
INSPECT PUSH ROD FOR WEAR OR DAMAGE
If necessary, replace the push rod.
ASSEMBLY OF MASTER CYLINDER
(See page CL-5)
1.
COAT PISTON WITH LITHIUM SOAP BASE GLYCOL
GREASE, AS SHOWN
2.
INSERT PISTON INTO CYLINDER
3.
INSTALL PUSH ROD ASSEMBLY
Insert and push in the push rod assembly, and using a
screwdriver, install the snap ring.
4.
INSTALL RESERVOIR TANK
Torque:
250 kg-em {18 ft-lb, 25 N·m)
Advertisement
Table of Contents
Troubleshooting
