Table of Contents
Advertisement
FA-8
Matchmarks
FRONT AXLE AND SUSPENSION - Front Axle Hub
FA1697
FA1485
REMOVAL OF FRONT AXLE HUB
(See page FA-7)
1..
REMOVE DISC BRAKE CALIPER
Remove the brake caliper from the steering knuckle and
suspend it with wire.
2.
REMOVE ROTOR DISC
Place matchmarks on the rotor disc and hub.
3.
CHECK BEARING PLAY IN AXIAL DIRECTION
Bearing play:
0.05 mm (0.0020 in.) or less
4.
DISCONNECT STABILIZER LINK
When disconnecting the stabilizer link, disconnect from
the bottom.
NOTE:
• If the ball joint stud turns together with the nut, use a
hexagon wrench to hold the stud.
• When disconnecting the tie rod end, to keep from
damaging the stabilizer link, disconnect the lower side
of the stabilizer link.
5.
DISCONNECT LOWER BALL JOINT AND TIE ROD END
(a)
Remove the two bolts holding the ball joint to the
steering knuckle.
Advertisement
Table of Contents
Troubleshooting
