Rep 3.1.1 Main Drive Motor; Rep 3.1.2 Main Drive Housing - Xerox WorkCentre 5022 Service Manual

REP 3.1.1 Main Drive Motor

Parts List on PL 3.1
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the Rear Cover. (REP 19.4.1)
2. Remove the Main Drive Motor. (Figure 1)
a. Disconnect the connector (x2).
b. Remove the screw (x2).
c. Remove the Main Drive Motor.
Figure 1 j0lj40301
Replacement
1. To install, carry out the removal steps in reverse order.
Version 1.0
WC 5022/5024
WARNING

REP 3.1.2 Main Drive Housing

Parts List on PL 3.2
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the Drum Cartridge. (REP 8.1.1)
2. Remove the Toner Cartridge. (PL 8.1)
3. Remove the Front Cover. (REP 19.1.1)
4. Remove the Top Cover. (REP 19.1.2)
5. Remove the Cartridge Guide. (REP 8.2.1)
6. Remove the Fusing Unit. (REP 7.1.1)
7. Remove the MSI. (REP 13.1.1)
8. Remove the L/H Cover. (REP 14.1.1)
9. Remove the Registration Chute. (REP 15.1.1)
10. Remove the Rear Cover. (REP 19.4.1)
11. Remove the Registration Roll. (REP 15.1.2)
12. Remove the HVPS. (REP 18.1.2)
13. Remove the Fusing Unit Plate. (Figure 1)
a. Remove the Bind Screw.
b. Remove the Fusing Unit Plate from the stud.
14. Remove the Fusing Unit Rear Bracket. (Figure 2)
a. Remove the screw (x2).
b. Remove the Fusing Unit Rear Bracket from the stud.
06/2014
4-19
WARNING
Figure 1 j0lj40302
Repairs and Asdjustments