Configuring Ip Addresses; Support Of Sub-Net Masks; Assigning Ip Addresses - IBM 4002-C4A Installation And User Manual

4. Enter the following commands to set the port configuration and read-only
Note: If you forget your super-user password, see the Release Notes.
Syntax: enable super-user-password | read-only-password |
port-config-password <text>
Passwords can be up to 48 characters long.

Configuring IP addresses

The switches implement separate data and control planes. This architecture affects
how you assign IP addresses. Table 6 outlines the interfaces to which you can
assign IP addresses.
In this table, "in band" refers to an interface over which user packets are routed,
while "out of band" refers to an interface over which control packets related to
system management are forwarded.
Table 6. Assigning IP addresses
Interface
Management interface
Any interface over which user
packets are routed
Any virtual interface over
which user packets are
routed
Loopback interface
This section describes the following:
v The B48C and B50C support of sub-net masks
v How to assign an IP address to a management interface
v How to assign an IP address to an interface or virtual interface over which user

Support of sub-net masks

The B48C and B50C support both classical IP network masks (Class A, B, and C
sub-net masks, and so on) and Classless Interdomain Routing (CIDR) network
prefix masks.
v To enter a classical network mask, enter the mask in IP address format. For
v To enter a prefix number for a network mask, enter a forward slash ( / ) and the
24
IBM Ethernet Switch c-series Installation and User Guide
Note: You must set the super-user password before you can set other types of
passwords.
passwords:
NetIron(config)# enable port-config-password <text>
NetIron(config)# enable read-only-password <text>
packets are routed
example, enter "209.157.22.99 255.255.255.0" for an IP address with a Class-C
sub-net mask.
number of bits in the mask immediately after the IP address. For example, enter
"209.157.22.99/24" for an IP address that has a network mask with 24 significant
("mask") bits.
Associated physical port
Single 10/100/1000 Mbps Ethernet
management port
Any network interface port
Any interface port
–
Out of band/In band
Out of band
In band
In band
In band