Customizable Message Waiting Indicator (MWI) Request URI
In Release 3.1, an Administrator can now enter a parameter in the configuration files to
customize the request-URI for MWI feature subscription. This new parameter is called "sip
linex mwi request uri".
This feature can be set on a per-line basis using the configuration files only.
Configuring Message Waiting Indicator (MWI) Request URI
Use the following procedure to configure an MWI request URI on the IP phone.
Configuration Files
For the specific parameter you can set in the configuration files, see Appendix A, the section,
Waiting Indicator Settings"
5-96
Note: "Sip Explicit MWI Subscription" must be enabled to use this
feature. For more information about the Sip Explicit MWI Subscription"
parameter, see
"Advanced SIP Settings (optional)"
on
page A-159.
on
page
4-83.
"Message
41-001343-01 Rev 02, Release 3.2.2