Aastra 9000i Series Administrator's Manual page 265

Ip sip phones
Hide thumbs Also See for 9000i Series:
Table of Contents

Advertisement

Configuring Autodial Using the Aastra Web UI
Use the following procedure to configure Autodial using the Aastra Web UI.
By default, your IP phone uses the global settings you specify for Autodial for all lines on your
IP phone. However, you can also configure Autodial on a per-line basis.
Aastra Web UI
Global Configuration
1
Click on Advanced Settings->Global SIP->Autodial Settings.
2
In the "Autodial Number" field, specify the SIP number that the IP phone dials whenever the IP
phone is off-hook. An empty (blank) value disables autodial on the phone.
For example: 8500
3
In the "Autodial Timeout" field, specify a value, in seconds, for the timer as follows:
If you want the IP phone to autodial the number immediately (hotline) whenever the IP phone is
off-hook, accept the default value of 0.
If you want to specify a length of time for the IP phone to wait before dialing the number, enter
the length of time (in seconds). For example: 30
Valid values are 0 to 120.
4
Click
4-102
to save your changes.
41-001343-01 Rev 02, Release 3.2.2

Advertisement

Table of Contents
loading

This manual is also suitable for:

6700i series9000i6700i

Table of Contents