Aastra 9000i Series Administrator's Manual page 132

VLAN
You can enable or disable VLAN and set specific VLAN IDs and priorities under Network
Settings.
Parameter In
IP Phone UI
Global Settings
VLAN Enable VLAN Enable
Other Priority Priority, Non-IP
Packet
LAN Port Settings (Port 0)
Phone VLAN ID VLAN ID
SIP Priority SIP Priority
RTP Priority RTP Priority
RTCP Priority RTCP Priority
41-001343-01 Rev 02, Release 3.2.2
Parameter in Parameters in
Aastra Web UI Configuration Files
tagging enabled
priority non-ip
VLAN id
tos priority map
Description
Enables or disables VLAN on the IP phones.
For more information, see Chapter 4,
(optional)" on page 4-51.
Specifies the priority value for non-IP packets.
For more information, see Chapter 4,
(optional)" on page 4-51.
VLAN is a feature on the IP phone that allows for
multiple logical Ethernet interfaces to send
outgoing RTP packets over a single physical
Ethernet as described in IEEE Std 802.3. On the IP
phone, you configure a VLAN ID that associates
with the physical Ethernet Port 0.
For more information, see Chapter 4,
(optional)" on page 4-51.
This parameter is based on the Type of Service
(ToS), Differentiated Services Code Point (DSCP)
setting for SIP (tos sip parameter), RTP (tos rtp
parameter) and RTCP (tos rtcp parameter). It is
the mapping between the DSCP value and the
VLAN priority value for SIP, RTP, and RTCP
packets.
You enter the tos priority map value as follows:
(DSCP_1,Priority_1)(DSCP_2,Priority_2).....(DSC
P_64,Priority_64)
where the DSCP value range is 0-63 and the
priority range is 0-7. Mappings not enclosed in
parentheses and separated with a comma, or with
values outside the ranges, are ignored.
For more information, see Chapter 4,
(optional)" on page 4-51.
"Virtual LAN
"Virtual LAN
"Virtual LAN
"Virtual LAN
3-45