Aastra 9000i Series Administrator's Manual page 109

Parameter in
Aastra Web UI
Switch Focus to Ringing
Line
Note: This option can
be set by both Users
and Administrators.
Call Hold Reminder
During Active Calls
Note: This option can
be set by both Users
and Administrators.
Call Hold Reminder
Note: This option can
be set by both Users
and Administrators.
3-22
Parameter in
Configuration Files
switch focus to ringing
line
call hold reminder during
active calls
call hold reminder
call hold reminder timer
Note: This option can be
set by an Administrator
only.
call hold reminder
frequency
Note: This option can be
set by an Administrator
only.
Enables or disables whether or not the UI focus is switched to a
ringing line while the phone is in the connected state.
For more information on this feature, see
Line" on page 5-82.
Enables or disables the ability for the phone to initiate a continuous
reminder tone on the active call when another call is on hold. When
this feature is disabled, a ring splash is heard when the active call
hangs up and there is still a call on hold.
For more information on this feature, see
During Active Calls" on page
Enables or disables the reminder ring splash timer to start as soon
as you put a call on hold (even when no other calls are active on the
phone). When enabled, the phone initiates a reminder ring splash
periodically for the single call on hold. When disabled, no reminder
ring splash is audible.
For more information on this feature, see
single hold)" on page 5-86.
Specifies the time delay, in seconds, that a ring splash is heard on an
active call when another call was placed on hold. For example, if a
call comes into Line 1, and then a call comes into Line 2 and you
answer Line 2, Line 1 is automatically placed on hold. While on the
active Line 2, after 7 seconds, a ring splash audio sounds on the line
reminding you that the call on Line 1 is still on hold. This timer begins
to increment after Line 2 is answered.
Notes:
1. This parameter is used with the "call hold reminder frequency"
parameter.
2. You must enable this "call hold reminder timer" parameter for it to
work.
3. A value of "0" disables the call hold reminder feature.
For more information on this feature, see
& Frequency" on page 5-88.
Specifies the time interval, in seconds, between each ring splash
sound on the active line. For example, if a call comes into Line 1,
and then a call comes into Line 2 and you answer Line 2, Line 1 is
automatically placed on hold. While on the active Line 2, after 7
seconds, a ring splash audio sounds on the line reminding you that
the call on Line 1 is still on hold (determined by the "call hold
reminder timer" parameter), and then the ring splash is heard again
after 60 seconds (determined by this parameter).
Notes:
1. You must enable the "call hold reminder" and/or "call hold
reminder during active calls" parameter(s), and the "call hold
reminder timer" parameter, for this parameter to work.
2. A value of "0" prevents additional rings.
For more information on this feature, see
& Frequency" on page 5-88.
Description
"Switch Focus to Ringing
"Call Hold Reminder
5-84.
"Call Hold Reminder (on
"Call Hold Reminder Timer
"Call Hold Reminder Timer
41-001343-01 Rev 02, Release 3.2.2