Aastra 9000i Series Administrator's Manual page 218

.
Aastra Web UI
Step Action
1 Click on Advanced Settings->Network->Type of Service,DSCP.
2 Select a Protocol field:
• "SIP"
or
• "RTP"
or
• "RTCP"
3 Enter a value from 0 to 63. Default values are as follows:
SIP = 26
RTP = 46
RTCP = 46
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map
the applicable priority to the Protocol setting as shown in the table
page 4-55 For more information, see the section
4 Click
Configuring VLAN (optional)
Use the following procedures to configure VLAN on the IP phone.
41-001343-01 Rev 02, Release 3.2.2
to save your settings.
Notes:
1.
VLAN is disabled by default. When you enable VLAN, the IP
phones use the default settings for each VLAN parameter. You can
change the default settings if required using the following procedure.
2.
PC Port parameters are not applicable to the 6730i IP Phone.
"DSCP Range/VLAN Priority"
"Configuring VLAN (optional)"
on
on page 4-55.
4-55