Aastra 9000i Series Administrator's Manual page 217

IP Phone UI
Step Action
3 Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4 Select Network Settings.
5 Select Type of Service DSCP.
6 Select Type of Service SIP.
or
Select Type of Service RTP.
or
Select Type of Service RTCP.
7 Enter a value for "Type of Service SIP". Default is 26.
or
Enter a value for "Type of Service RTP". Default is 46.
or
Enter a value for "Type of Service RTCP". Default is 46.
Valid values are 0 to 63.
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map
the applicable priority to the Protocol setting as shown in the table
page 4-53 For more information, see the section
8 Press Done (3 times) to save the changes.
Note: The session prompts you to restart the IP phone to apply the configuration settings
9 Select Restart.
For the 6739i:
1 Press the Options key on the phone to enter the Options List.
2 Press Advanced. A keyboard displays.
3 Enter the Administrator password using the keyboard. Default is "22222".
4 Press Network.
5 Press to scroll to the next screen.
6 Press Type of Service DSCP.
7 Press Type of Service SIP, and then enter a value for ToS. Default is 26.
8 Press Type of Service RTP, and then enter a value for ToS. Default is 46.
9 Press Type of Service RTCP, and then enter a value for ToS. Default is 46.
10 Press until the Options List screen displays.
11 Press Restart to restart the phone for the change to take affect.
4-54
"DSCP Range/VLAN Priority"
"Configuring VLAN (optional)"
41-001343-01 Rev 02, Release 3.2.2
on
on page 4-55.