Aastra 9000i Series Administrator's Manual page 176

Using Option 77 User Class on the IP Phone
DHCP Option 77 User Class is sent in DHCP request packets from the phone to the configuration
server. This Option 77 defines specific User Class identifiers to convey information about a
phone's software configuration or about its user's preferences. For example, you can use the User
Class option to configure all phones in the Accounting Department with different user preferences
than the phones in the Marketing Department. A DHCP server uses the User Class option to
choose the address pool for which it allocates an address from, and/or to select any other
configuration option.
An Administrator can configure the DHCP Option 77 User Class via the configuration files, the IP
Phone UI, and the Aastra Web UI.
Configuring DHCP Option 77 User Class on the IP Phone
Use the following procedures to configure DHCP Option 77 User Class on the IP Phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
Settings" on page A-13.
Aastra IP Phone UI
Step Action
1 Press Options, and then select Administrator Menu.
2 Select Network Settings.
3 Select DHCP Settings.
4 Select DHCP User Class.
5 In the "DHCP User Class" field, enter a DHCP User Class to apply to your phones, then press
DONE.
Valid values are up to 64 alpha-numeric characters. For example, "admin".
6 Restart the phone for the change to take affect.
41-001343-01 Rev 02, Release 3.2.2
Notes:
1.
If the User Class is not specified (left blank) in the DHCP request
packet, the phone does not send the User Class DHCP Option 77.
2.
Multiple User Classes inside a DHCP Option 77 are not supported.
3.
DHCP Option 77 may affect the precedence of DHCP Options,
dependent on the DHCP Server.
"DHCP Option
4-13