Firmware Installation Information; Description; Installation Considerations - Aastra 9000i Series Administrator's Manual

Ip sip phones

Hide thumbs Also See for 9000i Series:

Table of Contents

Firmware Installation Information

The firmware setup and installation for the IP phone can be done using any of the following:

Phone User Interface via the keypad (Phone UI)

Aastra Web-based user interface (Aastra Web UI)

When the IP phone is initialized for the first time, DHCP is enabled by default. Depending on the

type of configuration server setup you may have, the IP phone may download a firmware version

automatically, or you may need to download it manually.

The following considerations must be made before connecting the IP phone to the network:

If you are planning on using dynamic IP addresses, make sure a DHCP server is enabled and

running on your network.

If you are not planning on using dynamic IP addresses, see Chapter 4, the section,

"Configuring Network Settings Manually"

To install the IP phone hardware and cabling, refer to the model-specific

SIP IP Phone Installation Guide.

41-001343-01 Rev 02, Release 3.2.2

for manually setting up an IP address.

6700i series9000i6700i