Message Waiting Indicator Line
You can configure the Message Waiting Indicator (MWI) to illuminate for a specific line or for all lines. For example, if you
configure the MWI LED on line 3 only, the LED illuminates if a voice mail is pending on line 3. If you configure the MWI LED
for all lines, the LED illuminates if a voice mail is pending on any line on the phone (lines 1 through 9).
You configure the MWI indicator using the Aastra Web UI.
Configuring Message Waiting Indicator Line
Aastra Web UI
Use the following procedure to configure the message waiting indicator on a specific line or on all lines on the IP phone
Note:
"Message Waiting Indicator Line" parameter is set to ALL lines by default.
1.
Click on Basic Settings->Preferences->General.
2.
The "Message Waiting Indicator Line" field is set to ALL lines by default. If required, change the setting to a specific
line by selecting a line from the list. Valid values are All and lines 1 through 9.
3.
Click Save Settings.
41-001452-05 REV01 – 04.2014
Additional Features
.
167