D-Link xStack DES-3500 Series Manual page 71

disable syslog
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the syslog function on the Switch:
show syslog
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current status of the syslog function:
DES-3526:admin#show syslog
Command: show syslog
Syslog Global State: Enabled
DES-3526:admin#
create syslog host
Purpose
Syntax
Description
Parameters
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Used to enable the system log to be sent to a remote host.
disable syslog
The disable syslog command enables the system log to be sent to a
remote host.
None.
Only Administrator and Operator-level users can issue this command.
DES-3526:admin#disable syslog
Command: disable syslog
Success.
DES-3526:admin#
Used to display the syslog protocol status as enabled or disabled.
show syslog
The show syslog command displays the syslog status as enabled or
disabled.
None.
None.
Used to create a new syslog host.
create syslog host <index 1-4> ipaddress <ipaddr> {severity [informational | warning |
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]
The create syslog host command is used to create a new syslog host.
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are
four available indexes, numbered 1 through 4.
ipaddress <ipaddr> − Specifies the IP address of the remote host where syslog messages
will be sent.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the
Switch.
67