D-Link xStack DES-3500 Series Manual page 181

config 802.1x auth_parameter
Restrictions
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DES-3526:admin#config 802.1x auth_parameter ports 1–20
direction both
Command: config 802.1x auth_parameter ports 1–20 direction
both
Success.
DES-3526:admin#
config 802.1x auth_protocol
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the authentication protocol on the Switch:
DES-3526:admin# config 802.1x auth_protocol radius_pap
Command: config 802.1x auth_protocol radius_pap
Success.
DES-3526:admin#
config 802.1x init
Purpose
Syntax
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
supp_timeout <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535> - Configure the length of time to wait
for a response from a RADIUS server.
max_req <value 1-10> − Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable] − Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Only Administrator and Operator-level users can issue this
command.
Used to configure the 802.1x authentication protocol on the Switch.
config 802.1x auth_protocol [radius_eap | radius_pap]
The config 802.1x auth_protocol command enables users to
configure the authentication protocol.
radius_eap | radius_pap – Specify the type of authentication protocol
desired.
Only Administrator and Operator-level users can issue this
command.
Used to initialize the 802.1x function on a range of ports.
config 802.1x init {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
177