D-Link xStack DES-3500 Series Manual page 133

DES-3526:admin#show access_profile
Command: show access_profile
Access Profile Table
Access Profile ID : 1
Type
Owner
Masks
Offset 0-15
00000000
Offset 16-31
Offset 32-47
Offset 48-63
Offset 64-79
Access ID
Mode
Owner
Port
------------------------------------------------------------
Offset 0-15
00000000
Offset 16-31
Offset 32-47
Offset 48-63
Offset 64-79
CTRL+C ESC q
The show access_profile command will display the two access profiles created and their corresponding rules for every port on the
Switch.
config address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure address binding on the Switch:
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
: Packet Content Filter
: Address_binding
:
: 0x00000000 0000ffff
: 0x00000000 00000000
: 0xffff0000 00000000
: 0x00000000 00000000
: 0x00000000 00000000
: 1
: Permit
: Address_binding
: 1
: 0x00000000 0000ffff
: 0x00000000 00000000
: 0xffff0000 00000000
: 0x00000000 00000000
: 0x00000000 00000000
Quit SPACE n
Used to configure an IP-MAC Binding entry.
config address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all] | mode {arp | acl]}
This command will configure an IP-MAC Binding entry.
<ipaddr> - The IP address of the device where the IP-MAC binding is
made.
<macaddr> - The MAC address of the device where the IP-MAC binding
is made.
<portlist> - Specifies a port or range of ports to be configured for address
binding.
all – Specifies that all ports on the switch will be configured for address
binding.
mode – The user may set the mode for this IP-MAC binding settings by
choosing one of the following:
arp - Choosing this selection will set a normal IP-MAC Binding entry for
the IP address and MAC address entered.
acl - Choosing this entry will allow only packets from the source IP-MAC
binding entry created here. All other packets with a different IP
address will be discarded by the Switch. This mode can only be
used if the ACL Mode has been enabled in the IP-MAC Binding
Ports window as seen previously.
User Account Command Level – Administrator and Operator.
ffffffff
00000000
00000000
00000000
00000000
ffffffff
00000000
00000000
00000000
00000000
Next Page Enter Next Entry
129
0000ffff
00000000
00000000
00000000
0000ffff
00000000
00000000
00000000
a All