D-Link xStack DES-3500 Series Manual page 37

Command
delete snmp host
show snmp host
create trusted_host
config trusted_host
delete trusted_host
show trusted_host
enable snmp traps
enable snmp authenticate traps
show snmp traps
disable snmp traps
disable snmp authenticate traps
config snmp system_contact
config snmp system_location
config snmp system_name
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Syntax
Description
Parameters
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Parameters
<auth_string 32>
<ipaddr>
<ipaddr>
<ipaddr>| network<network_address> {snmp | telnet | ssh | http
| https}
[<ipaddr> | network <network_address>] [add|delete] {snmp |
telnet | ssh | http | https}
[all | ipaddr<ipaddr>| network<network_address>]
<sw_contact>
<sw_location>
<sw_name>
Used to create a new SNMP user and adds the user to an SNMP group that is also
created by this command.
create snmp user <snmp_username 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha <auth_password 8-20>]
priv [none | des <priv_password 8-16>] | by_key auth [md5 <auth_key 32-32> |
sha <auth_key 40-40>] priv [none | des <priv_key 32-32> ]]}
The create snmp user command creates a new SNMP user and adds the user to
an SNMP group that is also created by this command. SNMP ensures:
Message integrity − Ensures that packets have not been tampered with during
transit.
Authentication − Determines if an SNMP message is from a valid source.
Encryption − Scrambles the contents of messages to prevent it from being viewed
by an unauthorized source.
<snmp_username 32> − An alphanumeric name of up to 32 characters that will
identify the new SNMP user.
<groupname 32> − An alphanumeric name of up to 32 characters that will identify
the SNMP group the new SNMP user will be associated with.
encrypted – Allows the user to choose a type of authorization for authentication
using SNMP. The user may choose:
by_password – Requires the SNMP user to enter a password for authentication
and privacy. The password is defined by specifying the auth_password below.
This method is recommended.
by_key – Requires the SNMP user to enter a encryption key for authentication and
33