D-Link xStack DES-3500 Series Manual page 315

config gratuitous_arp periodical_send
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure gratuitous ARP intervals for the IPIF System:
DES-3526:admin#config gratuitous_arp send periodically ipif System
interval 5
Command: config gratuitous_arp send periodically ipif System
interval 5
Success.
DES-3526:admin#
enable gratuitous_arp trap and log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the System's interface gratuitous ARP log and trap:
DES-3526:admin#enable gratuitous_arp System trap log
Command: enable gratuitous_arp System trap log
Success.
DES-3526:admin#
show gratuitous_arp
Purpose
Syntax
Description
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Used to configure the interval for periodical sending of gratuitous ARP
request packets.
config gratuitous_arp send periodically ipif <ipif_name 12> interval
<value 0-65535>
This command is used to configure the interval for periodical sending of
gratuitous ARP request packets. By default, the interval is 0.
<ipif_name 12> - Interface name of L3 interface.
<value 0-65535> - Periodically send gratuitous ARP interval time in
seconds. 0- means it will not send gratuitous ARP periodically.
Only Administrator or Operator – level users can issue this command.
Used to configure the interval time to send gratuitous ARP request
packets periodically.
enable gratuitous_arp {ipif <ipif_name 12>} {trap |log}
disable gratuitous_arp {ipif <ipif_name 12>} {trap |log}
The command is used to enable gratuitous ARP trap and log states. The
switch can trap and log the IP conflict event to inform the administrator.
By default, the trap is disabled and event log is enabled.
<ipif_name 12> - Interface name of L3 interface.
Only Administrator or Operator – level users can issue this command.
Used to display gratuitous ARP configuration.
show gratuitous_arp {ipif <ipif_name>}
The show gratuitous_arp command is used to display gratuitous ARP
configurations.
311