D-Link xStack DES-3500 Series Manual page 49

DES-3526:admin#delete snmp host 10.48.74.100
Command: delete snmp host 10.48.74.100
Success.
DES-3526:admin#
show snmp host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
DES-3526:admin#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address
---------------
10.48.76.23
10.48.74.100
Total Entries: 2
DES-3526:admin#
create trusted_host
Purpose
Syntax
Description
Parameters
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Used to display the recipient of SNMP traps generated by the
Switch's SNMP agent.
show snmp host {<ipaddr>}
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps that are generated by the
Switch's SNMP agent.
<ipaddr> − The IP address of a remote SNMP manager that will
receive SNMP traps generated by the Switch's SNMP agent.
None.
SNMP Version
------------
V2c
V3
Used to create the trusted host.
create trusted_host <ipaddr> {snmp | telnet | ssh | http | https}
The create trusted host command creates the trusted host. The
switch allows you to specify IP addresses that are allowed to manage
the switch via in-band SNMP ,TELNET ,SSH, HTTP or HTTPs based
management software. These IP addresses must be members of the
Management VLAN. If no IP addresses are specified, then there is
nothing to prevent any IP address from accessing the switch,
provided the user knows the Username and Password.
When the access interface is not specified, the trusted host will be
created for all interfaces.
<ipaddr> − The IP address of the trusted host to be created.
snmp - Specifies trusted host for SNMP.
telnet - Specifies trusted host for TELENT.
ssh - Specifies trusted host for SSH
http - Specifies trusted host for HTTP.
Community Name/SNMPv3 User Name
-------------------
authpriv
45
---------
private
public