D-Link xStack DES-3500 Series Manual page 253

delete authen server_group
Parameters
Restrictions
Example usage:
To delete the server group "group_1":
DES-3526:admin#delete server_group group_1
Command: delete server_group group_1
Success.
DES-3526:admin#
show authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view authentication server groups currently set on the Switch.
DES-3526:admin#show authen server_group
Command: show authen server_group
Group Name
Protocol
------------
Darren
TACACS
tacacs
TACACS
tacacs+
xtacacs
Total Entries : 4
DES-3526:admin#
config authen parameter response_timeout
Purpose
Syntax
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
<string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be deleted.
User Account Command Level – Administrator.
Used to view authentication server groups on the Switch.
show authen server_group <string 15>
This command will display authentication server groups currently
configured on the Switch.
This command will display the following fields:
Group Name: The name of the server group currently configured on
the Switch, including built in groups and user defined groups.
IP Address: The IP address of the server host.
Protocol: The authentication protocol used by the server host.
<string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be viewed.
Entering this command without the <string> parameter will display all
authentication server groups on the Switch.
User Account Command Level – Administrator.
IP Address
---------------
10.53.13.2
10.53.13.94
(This group has no entry)
(This group has no entry)
Used to configure the amount of time the Switch will wait for a user
to enter authentication before timing out.
config authen parameter response_timeout <int 0-255>
249