D-Link xStack DES-3500 Series Manual page 20

enable telnet
Parameters
Restrictions
Example usage:
To enable Telnet and configure port number:
disable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Telnet protocol on the Switch:
DES-3526:admin#disable telnet
Command: disable telnet
Success.
DES-3526:admin#
telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To connect to a device through telnet with a IP address of 10.53.13.99:
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The "well-known" TCP port for
the Telnet protocol is 23.
Only Administrator and Operator-level users can issue this
command.
DES-3526:admin#enable telnet 23
Command: enable telnet 23
Success.
DES-3526:admin#
Used to disable the Telnet protocol on the Switch.
disable telnet
This command is used to disable the Telnet protocol on the Switch.
None.
Only Administrator and Operator-level users can issue this
command.
Used to Telnet another device on the network.
telnet <ipaddr> {tcp_port <value 0-65535>}
This command is used to connect to another device's management
through Telnet.
<ipaddr> - Enter the IP address of the device to connect through,
using Telnet.
tcp_port <value 0-65535> - Enter the TCP port number used to
connect through. The common TCP port number for telnet is 23.
Only Administrator and Operator-level users can issue this
command.
16