D-Link xStack DES-3500 Series Manual page 61

show config
Parameters
Restrictions
Example usage:
To view the current configuration settings:
DES-3526:admin#show config current_config
Command: show config current_config
#------------------------------------------------------------------------------------
#
#
#
# Copyright(C) 2000-2004 D-Link Corporation. All rights reserved.
#------------------------------------------------------------------------------------
# BASIC
config serial_port baud_rate 9600 auto_logout 10_minutes
enable telnet 23
enable web 80
# STORM
config traffic control 1-5 broadcast disable multicast disable unicast disable thres
hold 128
# GM
config sim candidate
CTRL+C ESC q Quit
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
1. Basic (serial port, Telnet and
web management status)
2. storm control
3. IP group management
4. syslog
5. QoS
6. port mirroring
7. traffic segmentation
8. port
9. port lock
10. 8021x
11. SNMPv3
12. management (SNMP traps
RMON)
current_config – Entering this parameter will display configurations entered without
being saved to NVRAM.
config_in_NVRAM - Entering this parameter will display configurations entered and
saved to NVRAM.
None.
DES-3526 Configuration
Firmware: Build 5.01-B47
SPACE n Next Page
13. vlan
14. FDB (forwarding data base)
15. MAC address table notification
16. STP
17. SSH
18. SSL
19. ACL
20. SNTP
21. IP route
22. LACP
23. ARP
24. IP
25. IGMP snooping
26. access authentication control
ENTER Next Entry a
57
(TACACS etc.)
All