D-Link xStack DES-3500 Series Manual page 251

show authen server_host
Parameters
Restrictions
Example usage:
To view authentication server hosts currently set on the Switch:
DES-3526:admin#show authen server_host
Command: show authen server_host
IP Address
---------
10.53.13.94
No Use
Total Entries : 1
DES-3526:admin#
create authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the server group "group_1":
DES-3526:admin#create authen server_group group_1
Command: create authen server_group group_1
Success.
DES-3526:admin#
config authen server_group
Purpose
Syntax
Description
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Key - Authentication key to be shared with a configured TACACS+
server only.
None.
User Account Command Level – Administrator.
Protocol
--------
TACACS
Used to create a user-defined authentication server group.
create authen server_group <string 15>
This command will create an authentication server group. A server
group is a technique used to group
TACACS/XTACACS/TACACS+/RADIUS server hosts into user
defined categories for authentication using method lists. The user
may add up to eight (8) authentication server hosts to this group
using the config authen server_group command.
<string 15> - Enter an alphanumeric string of up to 15 characters to
define the newly created server group.
User Account Command Level – Administrator.
Used to configure a user-defined authentication server group.
config authen server_group [tacacs | xtacacs | tacacs+ | radius |
<string 15>] [add | delete] server_host <ipaddr> protocol [tacacs |
xtacacs | tacacs+ | radius]
This command will configure an authentication server group. A server
group is a technique used to group
TACACS/XTACACS/TACACS+/RADIUS server hosts into user defined
Port Timeout Retransmit
---- ------- ---------------
49 5
247
Key
2