Table of Contents
Advertisement
config authen_enable
Restrictions
Example usage:
To configure the user defined method list "Permit" with authentication methods TACACS, XTACACS and local, in that
order.
DES-3526:admin#config authen_enable method_list_name
Trinity method tacacs xtacacs local
Command: config authen_enable method_list_name Trinity
method tacacs xtacacs local
Success.
DES-3526:admin#
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
authenticated using the XTACACS protocol from the remote
XTACACS server hosts of the XTACACS server group list.
tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from the remote
TACACS+ server hosts of the TACACS+ server group list.
radius – Adding this parameter will require the user to be
authenticated using the RADIUS protocol from the remote
RADIUS server hosts of the RADIUS server group list.
server_group <string 15> - Adding this parameter will
require the user to be authenticated using a user-defined
server group previously configured on the Switch.
local_enable - Adding this parameter will require the user to
be authenticated using the local user account database on
the Switch.
none – Adding this parameter will require no authentication
to access the Switch.
method_list_name – Enter a previously implemented method list
name defined by the user (create authen_enable). The user may
add one, or a combination of up to four (4) of the following
authentication methods to this method list:
tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from a remote
TACACS server.
xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from a remote
XTACACS server.
tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from a remote
TACACS+ server.
radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a remote
RADIUS server.
server_group <string 15> - Adding this parameter will
require the user to be authenticated using a user-defined
server group previously configured on the Switch.
local_enable - Adding this parameter will require the user to
be authenticated using the local user account database on
the Switch. The local enable password of the device can be
configured using the "config admin local_password"
command.
none – Adding this parameter will require no authentication
to access the administration level privileges on the Switch.
User Account Command Level – Administrator.
239
Advertisement
Table of Contents
