D-Link xStack DES-3500 Series Manual page 215

config loopdetect ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the loopdetect state to enable:
DES-3526:admin#config loopdetect ports 1-5 enable
Command: config loopdetect ports 1-5 enable
Success
DES-3526:admin#
enable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable loop-back detection on the switch:
DES-3526:admin#enable loopdetect
Command: enable loopdetect
Success
DES-3526:admin#
disable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable loop-back detection on the switch:
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Used to configure loop-back detection on the switch.
config loopdetect ports [<portlist> | all] | state [enable | disable]
Used to configure loop-back detection on the switch.
<portlist> - Specifies a range of ports for the loop-back detection
state [enable | disable] – Allows the loop-back detection to be disabled and
enabled.
Only Administrator and Operator-level users can issue this command.
Used to globally enable loop-back detection on the switch.
enable loopdetect
Used to globally enable loop-back detection on the switch.
none
Only Administrator and Operator-level users can issue this command.
Used to globally disable loop-back detection on the switch.
disable loopdetect
Used to globally disable loop-back detection on the switch.
none
Only Administrator and Operator-level users can issue this command.
211