Table of Contents
Advertisement
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
config cpu access_profile
ethernet − Specifies that the Switch will look only into the layer 2 part of each packet.
vlan <vlan_name 32> − Specifies that the access profile will apply to only to this VLAN.
source_mac <macaddr> − Specifies that the access profile will apply to this source MAC
destination_mac <macaddr> − Specifies that the access profile will apply to this
ethernet_type <hex 0x0-0xffff> − Specifies that the access profile will apply only to
ip − Specifies that the Switch will look into the IP fields in each packet.
vlan <vlan_name 32> − Specifies that the access profile will apply to only this VLAN.
source_ip <ipaddr> − Specifies that the access profile will apply to only packets with this
destination_ip <ipaddr> − Specifies that the access profile will apply to only packets with
dscp <value 0-63> − Specifies that the access profile will apply only to packets that have
icmp − Specifies that the Switch will examine the Internet Control Message Protocol
igmp − Specifies that the Switch will examine the Internet Group Management Protocol
tcp − Specifies that the Switch will examine the Transmission Control Protocol (TCP)
protocol_id <value 0-255> − Specifies that the Switch will examine the Protocol field in
udp − Specifies that the Switch will examine the Transmission Control Protocol (TCP)
protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field in
Parameters
packet_content_mask – Specifies that the Switch will mask the packet header beginning
address.
destination MAC address.
packets with this hexadecimal 802.1Q Ethernet type value in the packet header.
source IP address.
this destination IP address.
this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet
header
(ICMP) field within each packet.
•
type <value 0-255> − Specifies that the access profile will apply to this
ICMP type value.
•
code <value 0-255> − Specifies that the access profile will apply to this
ICMP code.
(IGMP) field within each packet.
•
type <value 0-255> − Specifies that the access profile will apply to
packets that have this IGMP type value.
field within each packet.
•
src_port <value 0-65535> − Specifies that the access profile will apply
only to packets that have this TCP source port in their TCP header.
•
dst_port <value 0-65535> − Specifies that the access profile will apply
only to packets that have this TCP destination port in their TCP header.
each packet and if this field contains the value entered here, apply the following
rules.
field within each packet.
•
src_port <value 0-65535> − Specifies that the access profile will apply
only to packets that have this UDP source port in their header.
•
dst_port <value 0-65535> − Specifies that the access profile will apply
only to packets that have this UDP destination port in their header.
each packet and if this field contains the value entered here, apply the following
rules.
•
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to
the IP protocol ID and the mask options behind the IP header.
with the offset value specified as follows:
•
offset_0-15 - Enter a value in hex form to mask the packet from byte 0 to
byte 15.
•
offset_16-31 - Enter a value in hex form to mask the packet from byte 16
to byte 31.
196
Advertisement
Table of Contents
