D-Link xStack DES-3500 Series Manual page 168

enable dhcp_relay
Parameters
Restrictions
Example usage:
To enable DHCP relay:
disable dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable DHCP relay:
config dhcp_relay option_60 state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the state of dhcp_relay option 60 :
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
None.
Only Administrator and Operator-level users can issue this command.
DES-3526:admin#enable dhcp_relay
Command: enable dhcp_relay
Success.
DES-3526:admin#
Used to disable the DHCP/BOOTP relay function on the Switch.
disable dhcp_relay
This command is used to disable the DHCP/BOOTP relay function on the
Switch.
None.
Only Administrator and Operator-level users can issue this command.
DES-3526:admin#disable dhcp_relay
Command: disable dhcp_relay
Success.
DES-3526:admin#
Used to config dhcp_relay opton_60 state.
config dhcp_relay option_60 state [enable|disable]
This decides whether dhcp_relay will process the DHCP option 60 or not.
When option_60 is enabled, if the packet does not have option 60, then the
relay servers cannot be determined based on option 60. The relay servers
will be determined based on either option 61 or per IPIF configured
servers. If the relay servers are determined based on option 60 or option
61, then per IPIF configured servers will be ignored. If the relay servers are
not determined either by option 60 or option 61, then per IPIF configured
servers will be used to determine the relay servers.
state - Enable:enable the fuction dhcp_relay use option_60 rules to relay
dhcp packet
Disable:disable the fuction dhcp_relay use option_60 rules to relay dhcp
packet
Only Administrator and Operator-level users can issue this command.
164