D-Link xStack DES-3500 Series Manual page 196

config access_profile
port <portlist> - Specifies the port number on the Switch to permit or deny access for the rule.
Parameters
permit - Specifies the rule permit access for incoming packets on the previously specified port.
priority <value 0-7> − Specifies that the access profile will apply to packets that contain this
{replace_priority}
replace_dscp_with <value 0-63> − Allows users to specify a new value to be written to the
deny - Specifies the rule will deny access for incoming packets on the previously specified
port.
delete access_id <value 1-65535> - Use this to remove a previously created access rule of a
profile ID. For information on number of rules that can be created for a given port, lease see
the introduction to this chapter.
time_range - Specifies the time range settings.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the access profile with the profile ID of 1 to filter frames on port 7 that have IP addresses in the range
between 10.42.73.0 to 10.42.73.255:
DES-3526:admin# config access_profile profile_id 1 add access_id 1 ip
source_ip 10.42.73.1 port 7 deny
Command: config access_profile profile_id 1 add access_id 1 ip source_ip
10.42.73.1 port 7 deny
Success.
DES-3526:admin#
show access_profile
Purpose
Syntax
Description
Parameters
Restrictions
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
value in their 802.1p priority field of their header for incoming packets on the previously
specified port.
-
Allows users to specify a new value to be written to the priority field of an
incoming packet on the previously specified port.
DSCP field of an incoming packet on the previously specified port.
Used to display the currently configured access profiles on the
Switch.
show access_profile {profile_id <value 1-255>
{access_id <value 1-65535>}}
The show access_profile command is used to display the currently
configured access profiles.
profile_id – Specify the profile id to display only the access rules
configuration for a single profile ID. The user may enter a profile ID
number between 1 – 255, yet, remember only 9 access profiles can
be created on the Switch
access_id - Specify the access ID to display the access rule
configuration for the access ID. For information on number of rules
that can be created for a given port, please see the introduction to this
chapter.
None.
192