D-Link xStack DES-3500 Series Manual page 192

create access_profile
protocol_id <value 0-255> − Specifies that the Switch will examine the protocol field in each
packet and if this field contains the value entered here, apply the following rules
packet_content_mask – Specifies that the Switch will mask the packet header beginning
with the offset value specified as follows:
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To create an access list rules:
DES-3526:admin#create access_profile ip vlan source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type code permit profile_id
101
Command: create access_profile ip vlan source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type code permit profile_id
101
Success.
DES-3526:admin#
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
src_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the destination port.
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP protocol ID
and the mask options behind the IP header.
offset_0-15 – Enter a value in hex form to mask the packet from the beginning of the
th
packet to the 15 byte.
offset_16-31 – Enter a value in hex form to mask the packet from byte 16 to byte 31.
offset_32-47 – Enter a value in hex form to mask the packet from byte 32 to byte 47.
offset_48-63 – Enter a value in hex form to mask the packet from byte 48 to byte 63.
offset_64-79 – Enter a value in hex form to mask the packet from byte 64 to byte 79.
profile_id <value 1-255> − Sets the relative priority for the profile. Priority is set relative to
other profiles where the lowest profile ID has the highest priority. The user may enter a
profile ID number between 1 – 255, yet, remember only 9 access profiles can be
created on the Switch
188